 |
| The bearing & headcup, pack with lots of grease. |
 |
| Fitting the home made puller |
 |
| Tighten down the yoke |
 |
| Front end on... and staying on!! |
Thursday, 23 September 2010
Installing the Front End
Decided to start installing the front end this evening………..hmmmm, those bearings were tight!! I made up a bearing puller out of 10mm bar so I could slowly pull them in with lots of grease… took a few hours to get them seated…. I definitely wouldn’t want to get them out again!!
The forks and bars are on and I think that ‘Old Springer’ looks really cool… offered the front wheel up to get an idea of how she will look.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment